Tachometers single red display:
Count rotation speeds to 9999 Rotation Per Minutes. One sensor provided.
Double Tachometers LCD display:
Count 2 rotation speeds from 48 to more than 10000 Rotation Per Minutes. Two sensors are provided so that two different speed can be mesured at the same time.  ex: engine and propeler axe or two different engine.

RS232 / NMEA Tachometer:
Small PCB (58x19x13mm ). Optical sensor, DB9 RS232 connector and the supply wire are connected to it. 7 to 14VDC. 28 to13050RPM, $OPRPM*XXXXX at 4800B/s.

Board Intercom:
4 channels intercom, 4x20W, 12 or 24 Vdc. Panel 12x12cm  -  4.7x4.7 inch.
Front and rear MIC input. automatic function of foghorn, warning and horn signal switch.

Bow propeller positionner:
Panel indicator with bow propeller positioning button for the wheel house side and a axial position sensor (encoder) mounted on the vertical (Z) axe of the bow propeller. Panel 16x12cm - 6.3x4.7 inch + encoder provided 60x80mm

360 degrees indicator:
Indicator panel 32 positions. Panel 12x12cm - 4.7x4.7 inch + encoder provided 60x80mm

Clinometer: To see if the barge is charged horizontally. External indicators (7 lamps) can be directly connected. 24 Vdc, panel 16x12cm - 6.3x4.7 inch

Motor Alarm:
Input accept either Normally Closed or Normally Open sensor. 2 input for engine Temp + Pressure.
2 input for Gear Temp + Pressure. One extra input, relais output, programmable for each Channel.
Panel 6x12cm (2.4x4.7in) , 12 / 24 Vdc.

Anemometer:
Measure Wind speed to 15 Beaufort. Maximum speed indication. With speed sensor.
Panel 12x6cm (4.7x2.4inch) 12 / 24 volt

Anemometer + Wind direction:
Wind speed up to 13 Beaufort(>160km/h), 16 Direction indicator. With speed + direction sensor.
Panel 18x18cm (±7x7inch) 12 / 24 volt. + NMEA output Speed/Dir.
  
Bilge Alarm:
5 channels with pomp control, 12/24Vdc. Panel 6x12cm - 2.4x4.7inch
Programmable positive or negative input, relais and buzzer for each channels.

Board lights 1:
Complete panel to take care of the board lights. Switches, fuses, control all in one. Nothing has to be added to it, except the lamps. 12 / 24 Vdc, panel 12x12cm - 4.7x4.7 inch 8 lamps.

Board lights 2:
Complete panel to take care of the board lights. Switches, fuses, control all in one. Nothing has to be added to it, except the lamps. 12 / 24 Vdc, panel 12x16cm - 4.7x6.3 inch 11 lamps.

Accu Control: Small and smart programmable system. Watching the accumulators. Can start and stop the generator on is own to charge the batterie. Panel 12x12cm - 4.7x4.7 inch

UHF remote control:
7 channel with relais output.

Immediat Turn Sens Indicator:
Turn sens alarm for reversible engine.